View the manual for the Taylor here, for free. This manual comes under the category Weather stations and has been rated by 1 people with an average of a 8. This manual is available in the following languages: English. Is your question not listed? Home Weather stations Taylor Taylor manual. Instruction Manual. Digital W ireless W eather. Station with W ind Speed Sensor.
Ask a question. Richard Knodel, No comments 0. How do you set the time on the unit? Remove the battery compartment cover, located on the back of the receiver unit. Insert 2 AA batteries lithium recommended as indicated by the polarity symbols marked inside the battery compartment.
It will then transmit these readings back to the home receiver unit, up to a distance of feet. Before mounting the remote Wind Gauge Sensor, measure the distance between the monitor and the sensor to be sure they are within an effective transmission range within feet , and that there Replace the battery compartment cover, and replace and tighten the screws.
The display will begin to flash as the receiver searches for the remote sensor signal. If necessary, mount and ground a mast at the selected location such as a roof or fence post as directed in the instructions provided by the mast not included. Select a location on an open, flat area of ground with the fewest obstructions possible for best wind accuracy.
Choose a spot with soft soil, so as not to damage the mast when going into the ground, but firm enough that the mast will not tip over after going in the ground.
Be sure the batteries are removed from the Wind Gauge Sensor before the calibration: Since the Sensor will orient north right after the batteries are installed, the wind vane needs to be pointing north first, otherwise Page 13 Wind Gauge Sensor that is included in this package. Select a location for the remote sensor that is within the effective transmission range. To set the time and date: 1.
The time display will show the default year. Remove the battery compartment cover, located on the back of the receiver unit. Insert 2 AAA batteries as indicated by the polarity symbols marked inside the battery compartment. Page 7: Assembling Instructions Assembling Instructions 1. Properly align the compass and wind cup sensor together to create the wind base; do not press too hard otherwise damage may occur.
Insert the connector tube to the bottom of the wind cup sensor and fasten with an M3x22 screw with nut included. It will then transmit these readings back to the home receiver unit, up to a distance of feet. Page 9: Operation Operation After battery installation, the total display mode will lasts 3 seconds and then enter the normal mode.
Page 10 1. Users can set clock and relative settings in this mode. Page 11 2. In this mode, users can adjust settings related to indoor temperature. Press [NEXT] to toggle the mode of parameters: Indoor temperature unit setting Users can adjust indoor temperature unit in this mode.
Page 12 Outdoor temperature display setting Users can adjust the outdoor temperature display settings. The following diagram is the order of the outdoor temperature setting: Outdoor temperature unit setting Users can adjust outdoor temperature unit in this mode.
Page 13 4. In this mode, users can adjust settings related to the wind speed. Page 14 6.
0コメント